The motherboard power connector, known as DC Jack, is essential to ensure your laptop charges properly ⚡.
Over time, this component can fail due to:
🔄 Wear and tear from connecting and disconnecting the charger many times.
💥 Internal breakage due to falls or blows.
❄️ Cold or defective weld.
Changing the power connector
🔍 Symptoms of a damaged DC Jack
🛑 The laptop won't turn on and the battery is dead.
⚡ It does not charge the battery even when it is connected.
🔄 Charge only if you move the connector to a certain position.
✨ Electric spark when connecting the charger.
🔥 Burning smell when plugged in.
If you notice any of these symptoms, the fault could be in the DC jack. Before replacing the charger, check this component 🔧.
Bad welding.
Unsoldered and broken connector.
Broken connector. No positive.
🛠️ Step-by-step guide to replacing the DC Jack
🔧 Disassemble the laptop (keyboard, screen, connectors, etc.) to access the motherboard.
🔥 Carefully remove the damaged connector.
🖤 Clean the solder points by removing old residue.
🧴 Place the new connector and solder it precisely.
💨 Take the opportunity to clean the ventilation and dissipation system.
🔩 Put everything back together and check that it works.
💡 Note:
Some laptops use Floating DC Jacks which are easier to replace because they are not soldered directly to the board.
⚠️ Important warning
A damaged DC jack can cause serious motherboard failure or render the laptop unusable.
If you're inexperienced with soldering and disassembly, it's best to take your equipment to a trusted service center to avoid further damage 🛡️.
